DOUBLE SHEET DETECTOR MESIN OFFSET OLIVER 52 - 8 - 58 - 12 - 66 - 72

DOUBLE-SHEET DETECTOR
Operating Procedure
(1) Turn the ON-OFF switch [1] ON. Then the indicator light [2] illuminates.
(2) Fully turn the adjusting knob clockwise and make sure that the needle of the meter [3] is at extreme right-hand side (blue zone).








(3) Insert a sheet of paper to be run between the light emitting and receiving elements as shown in the Fig. 2.
(4) Place the selector switch [5] in the METER position and turn the knob [4] counterclockwise (toward “0”) so that the needle of the meter [3] comes slightly to the right side (blue zone). Fig. 3.




(5) Insert another sheet of paper between the emitting ang receiving elements and check to see needle of the meter [3] moves to the left side (red zone) as shown in the Fig. 4.





*Note :
 PlacetheTHIN THICKselector switch [6] in the THIN or THICK position according to the thickness of paper to be used.

(6) Place the selector switch [5] in the CONT. Side ang push the CHECK push button [7]. Then the timing light [8] flicker at a time. If two sheets of paper are inserted between the light emitting and receiving elements, the ALARM light [9] illuminates at the same time.
When the selector switch [5] is in the CONT. Position and CHECK push button [7] is pushed, with two sheets of paper placed between the emitting and receiving elements, the timing light [8] flickers at a time and the ALARM light illuminates simultaneously.
This is how the machine stops when two sheets of paper are detected. If the CHECK push button [7] is pushed with a sheet of paper placed, are timing light [8] flickers and the ALARM light does not illuminate. The machine goes on working as it is.

*Note :
1.The machine does not work when the selector switch [5] is on the METER side.                                  2.Turn the ON-OFF switch [1] OFF when suffering losses in printing or binding.
                                                                              

BY : BERKAH MANDIRI MESINDO